Chevrolet 2005 Malibu Dokumentacja Pobierz pdf (Strona 120)

Turn and Lane-Change Signals

The turn signal has two upward (for right) and

two downward (for left) positions. These positions allow

you to signal a turn or a lane change.

To signal a turn, move the lever all the way up or down

to the latched position. When the turn is ﬁnished, the

lever will return automatically.

An arrow on the instrument

panel cluster will ﬂash in

the direction of the

turn or lane change.

To signal a lane change, just raise or lower the lever

until the arrow starts to ﬂash. Hold it there until you

complete your lane change. The lever will return by itself

when you release it.

A warning chime signal will come on if you have left

your turn signal on for more than 2/3 mile (1 km).

As you signal a turn or a lane change, if the arrows

ﬂash rapidly, a signal bulb may be burned out and other

drivers won’t see your turn signal.

If a bulb is burned out, replace it to help avoid an

accident. If the arrows don’t go on at all when you signal

a turn, check for burned-out bulbs and then check the

fuse. See Fuses on page 5-85.

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high beam,

push the turn signal/multifunction lever away from you.

When the high beams are

on, a light on the

instrument panel cluster

also will be on if the

ignition is in ON.

To change the headlamps from high beam to low beam,

pull the turn signal lever toward you.

Flash-to-Pass

This feature lets you use your high-beam headlamps

momentarily to signal a driver in front of you that

you want to pass.

To use it, pull the turn signal/multifunction lever toward

you until the high-beam headlamps come on, then

release the lever to turn them off.

3-8

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 409 410

Brak uwag

Chevrolet 2005 Malibu Dokumentacja Strona 120